Pool screen door won’t close — or won’t latch
Almost always the door frame has racked out of square from worn rollers, loose corner keys, or a sagging hinge side — doors take more open-close cycles than any other part of the cage. Won’t-close-at-all usually means a dropped hinge side or bent track; closes-but-won’t-latch usually means the latch and keeper no longer line up.
Racked, not just misaligned
A screen door is held square by its corner keys and its rollers or hinge. Over thousands of open-close cycles — and doors take more cycles than any other part of a cage — the corners loosen, a roller wears flat, or the hinge side sags under the door’s own weight. The door frame stops being a true rectangle, which shows up two ways:
- Won’t close at all. The door binds against the track or threshold before it reaches the frame — usually a dropped hinge side or a bent track.
- Closes but won’t latch. The door reaches the frame but the latch and keeper no longer line up — usually corner-key or roller wear rather than a track problem.
On an older Longwood frame, corroded fasteners at the hinge side are a common contributor on top of ordinary wear — the same decades-of-humidity story that affects every fastener on these cages. More on that →
What it costs to fix
These are third-party market estimates, not our prices and not a quote. They are collected from published Florida and Orlando-area cost guides — two of the three sources are themselves screen contractors, and none of them is Longwood-specific. Longwood Rescreening's own per-panel and full-cage pricing is and will replace these ranges before launch.
| Job | Published range | Source |
|---|---|---|
| Kickplate replacement only | $80–$160 per panel | A Screen Repair, Orlando, 2026 |
| Door rescreen with new kickplate | $90–$180 | A Screen Repair, Orlando, 2026 |
| Full door rebuild or replacement | $250–$650 | A Screen Repair, Orlando, 2026 |
A simple adjustment — tightening corner keys, swapping a roller — often costs less than any of the above; no source publishes that as a separate line item, so it typically falls under a minimum service call instead. Full door repair cost breakdown →
Questions people actually type
These are verbatim Google and DuckDuckGo autocomplete strings, kept in the wording people type rather than tidied up into marketing questions.
Searched aspool screen door won't close
The door frame has almost always racked out of square — worn rollers, loose corner keys, or a hinge side that has sagged under its own weight over thousands of open-close cycles. A door that binds before it reaches the frame usually means a dropped hinge side or bent track; a door that closes but won’t latch usually means the latch and keeper no longer line up. On an older Longwood frame, corroded hardware at the hinge side is a common contributor on top of ordinary wear.
Related
Get the door looked at
Tell us whether it won't close at all or closes but won't latch — that alone usually tells us which part failed.